NetBatch Manual

Commands
NetBatch Manual—522460-004
6-117
RESET ATTACHMENT-SET Command
rptime
specifies the job submit time if the report is valid after job submit, or the job start
time if the report is valid after job run.
Consideration
The REPORT-JOB command is available to all users.
RESET ATTACHMENT-SET Command
Use the RESET ATTACHMENT-SET command to remove attachment-set attributes
from BATCHCOM’s working-attributes set.
attribute
is one of these attachment-set attributes:
ASSI[GN] [ ASSIGN-name ]
DEFI[NE] [ DEFINE-name ]
PA[RAM] [ PARAM-name ]
SEC[URITY]
TEM[PORARY]
If you omit attribute, BATCHCOM removes all attachment-set attributes except
DEFINE =_DEFAULTS from the working-attributes set. If you specify ASSIGN,
HOLD-REPORT Job-Submit Jobs that are put on hold
MISC-REPORT Job-Submit Jobs configured under a particular
class, or satisfying the job-filter
attribute
PRED-REPORT Job-Submit Master jobs of jobs satisfying thejob-
filter attribute
SUCR-REPORT Job-Submit Dependent jobs of jobs satisfying the
job-filter attribute
TAPE-REPORT Job-Submit Jobs that require tapedrives to run
ABEND-REPORT Job-Run Job RunJobs that abended
LATE-REPORT Job-Run Job RunJobs not run at the scheduled
time
RUNNOW-REPORT Job-Run Job RunJobs started by the RUNNOW
command
SUCCESS-REPORT Job-Run Job RunJobs that are complete
successfully
RESE[T] [ ATTACHMENT-SET ] [ attribute [ , attribute ]… ]