NetBatch Manual

Commands
NetBatch Manual—522460-004
6-123
RESET SCHEDULER Command
attribute
is one of these scheduler attributes:
If you omit attribute, BATCHCOM removes all scheduler attributes from the
working-attributes set.
Considerations
•
The RESET SCHEDULER command is available to all users.
•
You can omit the object keyword SCHEDULER from the RESET SCHEDULER
command only when SCHEDULER is the current assumed object. For more
information, see ASSUME SCHEDULER Command on page 6-73.
Examples
•
This example shows the RESET SCHEDULER command removing two specified
scheduler attributes from the working-attributes set:
4} SHOW SCHEDULER
SCHEDULER ATTRIBUTES
submit-allowed: On
default-executor-program: \MELBDEV.$SYSTEM.SYSTEM.TACL
default-pri: 119
default-selpri: 3
default-out: \MELBDEV.$S.#FPP
default-class: STANDARD-CLASS
default-stop-on-abend: Off
5} RESET SCHEDULER DEFAULT-OUT, DEFAULT-STOP-ON-ABEND
6} SHOW SCHEDULER
SCHEDULER ATTRIBUTES
submit-allowed: On
default-executor-program: \MELBDEV.$SYSTEM.SYSTEM.TACL
default-pri: 119
default-selpri: 3
default-class: STANDARD-CLASS
AT-A[LLOWED] D[EFAULT]-
MAXPRINTP[AGES]
INI[TIATION]
B[ACKUPCPU] D[EFAULT]-O[UT] LO[CALNAMES]
CAT[CHUP] D[EFAULT]-P[RI] M[AX]-[CONCURRENT]-
[JOBS]
D[EFAULT]-C[LASS] D[EFAULT]-SE[LPRI] M[AX]-[PRI]
D[EFAULT]-E[XECUTOR]-
[PROGRAM]
D[EFAULT]-ST[ALL] S[UBMIT]-A[LLOWED]
D[EFAULT]-H[IGHPIN] D[EFAULT]-[STOP]-
[ON]-[ABEND]
TA[PEDRIVES]
D[EFAULT]-
MAXPRINTL[INES]
EM[S]