NetBatch Manual

Commands
NetBatch Manual—522460-004
6-130
SET ATTACHMENT-SET Command
JOB STATUS
JOB JOBNAME USERID LOG STATE CLASSNAME
---- ---------------- ------- ---- ----------- ---------
82 ZBAT-0082 255,205 READY DEFAULT
56> BATCHCOM $ZBAT; RUNNOW JOB 82
Job ZBAT-0082 Jobnumber 82 runnow completed
57> BATCHCOM $ZBAT; STATUS JOB *
JOB STATUS
JOB JOBNAME USERID LOG STATE CLASSNAME
---- ---------------- ------- ---- ----------- ---------
82 ZBAT-0082 255,205 681 EXECUTING DEFAULT
58> BATCHCOM $ZBAT; STATUS EXECUTOR *
EXECUTOR STATUS
EXECUTOR CPU STATE JOB CLASS
------------------------ --- ------ ---- -------
__TEMP_EXEC_82 3 DELETE 82 DEFAULT
59> FUP COPY LOGABU,,SHARE .
.
ADD JOB ZBAT-0082 C_DEFAULT:2 J_82 U_255,205
H_\QA.$ZTN0.#PTY4
LIST JOB ZBAT-0082 RUNNOW J_82 U_255,205 H_\QA.$ZTN0.#PTY4
ADD EXECUTOR __TEMP_EXEC_82 CPU 3
BEGIN JOB (SUPER.FPP)ZBAT-0082:1 E___TEMP_EXEC_82 L_681 J_82
P_DELAY \QA.$Z703:17393453 U_255,205
UPDATE EXECUTOR __TEMP_EXEC_82
LIST JOB ZBAT-0082 EXECUTING J_82
START EXECUTOR-PROGRAM U_255,205 J_82 P_DELAY
\QA.$Z703:17393453
STOP CC_0 EXECUTOR-PROGRAM J_82 \QA.$Z703:17393453
DELETE EXECUTOR __TEMP_EXEC_82
FINISH JOB ZBAT-0082 T_0:0:0:12 J_82 P_DELAY
DELETE JOB ZBAT-0082 J_82
SET ATTACHMENT-SET Command
Use the SET ATTACHMENT-SET command to specify attachment-set attributes in
BATCHCOM’s working-attributes set. Attachment sets added later by the ADD
ATTACHMENT-SET command adopt these attributes (which override attachment-set
defaults) unless that command specifies otherwise.
attribute
is one of these attachment-set attributes (see Section 7, Attributes):
( ASSI[GN] ASSIGN-name , ASSIGN-attributes )
( DEFI[NE] DEFINE-name-1 , [ LIK[E] DEFINE-name-2 , ]
[ CLASS DEFINE-class , ]
DEFINE-attribute [ , DEFINE-attribute ]… )
( PA[RAM] PARAM-name PARAM-value )
SEC[URITY] " security "
TEM[PORARY] { OF[F] | ON }
SET [ ATTACHMENT-SET ] attribute [ , attribute ]…