NetBatch Manual

Commands
NetBatch Manual—522460-004
6-133
SET CLASS Command
14} INFO ATTACHMENT-SET (SUPER.DRAT)2, DETAIL
ATTACHMENT-SET ATTRIBUTES for (SUPER.DRAT)2
security: "AAAA"
temporary: Off
attachments: DEFINE =I, CLASS SPOOL, LOC \DEV.$I, OWNER
"255,1"
DEFINE =S, CLASS SPOOL, LOC \DEV.$S, OWNER
"255,1"
DEFINE =_DEFAULTS, CLASS DEFAULTS, VOLUME
$A.NB
ASSIGN ACCOUNT-REC, $D6.FIN.ACCNT
PARAM SHIFT NIGHT
SET CLASS Command
Use the SET CLASS command to specify the value of the INITIATION class attribute in
BATCHCOM’s working-attributes set. Classes added later by the ADD CLASS
command adopt this attribute unless that command specifies otherwise.
attribute
specifies this class attribute (see Section 7, Attributes):
INI[TIATION]BBC{( AALVS1(OF[F],ON) )
Considerations
•
The SET CLASS command is available to all users. However, you must be a
NetBatch supervisor to use the ADD CLASS command.
•
You can display the INITIATION attribute in the working-attributes set by using the
SHOW CLASS command.
•
The default value of the INITIATION attribute in the working-attributes set is ON.
You can use the RESET CLASS command to restore this value during a
BATCHCOM session.
•
JOBCLASS is an alias of the object keyword CLASS.
•
You can omit the object keyword CLASS from the SET CLASS command only
when CLASS is the current assumed object. For more information, see ASSUME
CLASS Command on page 6-70.
SET [ CLASS ] attribute