NetBatch Manual

Software Installation
NetBatch Manual—522460-004
2-3
Installation Procedure
Installation Procedure
The NetBatch software installation procedure varies, depending on whether NetBatch
product files are on a SUT or SPR tape. For the latter, the procedure also varies
depending on whether the files make up a full product release or a partial release only.
For these reasons, detailed installation instructions appear in the softdoc supplied with
the files and not in this section. However, this section gives an overview of the
installation procedure with cross-references to softdoc instructions where necessary.
Step 1: Log On as the Super ID
Log on as the super ID (255,255). This lets you perform all installation tasks and avoid
security violations that disrupt installation.
9150 DDL data definition language D20 or later
9050 NonStop OS G02.00 or
later
0295 ENFORM PLUS G02.00 or
later
Figure 2-1. NetBatch Software Installation Overview
Note. ENFORM PLUS (T0295D46) is required only for the job-run history report generation
feature.
Table 2-3. NetBatch Installation Prerequisites (page 2 of 2)
Prerequisite
BATCHCAL
BATCHCOM
BATCHIMU
BATCHLIB
BATCHUTL
NBEXEC
NETBATCH
SYSTEM
EXECUTE
NBEXDOC
NBSPIEX
ZNETBTCH
SBATTMPL
ZBATTMPL
ZTEMPL
ZBATC
ZBATCOB
ZBATDDL
ZBATTACL
ZBATTAL
ZSPIDEF
ZBATSEGF
ZSPISEGF
NetBatch TSVs
DSM/SCM
IPM
tape
SUT
VST005.vsd