NetBatch Manual

Messages
NetBatch Manual—522460-004
A-12
Message Descriptions
0548-W
Cause. A job was submitted or altered to run at or after a time in the past.
Effect. The job runs.
Recovery. Not applicable.
0549-I
Cause. In response to a STATUS command, the process-handle-count process
handles started by a NetBatch job could not be accommodated in the Reply buffer due
to resource limitations.
Effect. None. The command completes successfully but displays this informational
message.
Recovery. To find out the job whose process handles have been omitted:
1. Set the Batchcom command Display-Spi to ON.
2. Issue the STATUS JOB command. From the SPI information, detemine the job that
returns the informational message.
This is the job for which process handles have been omitted.
3. Set the Batchcom command Display-Spi to OFF.
4. To see the maximum possible process handles for the job, use STATUS JOB job-
number/job-name, DETAIL.
2048-E
Cause. The ACTIVATE JOB command specified a nonsuspended job. The command
only operates on suspended jobs (state SUSPENDED).
Effect. The command failed.
Recovery. Not applicable.
AT/AFTER specifies a time in the past.
process-handles-count Process handles omitted
Job is not suspended; ACTIVATE command ignored.