NetBatch Manual

Messages
NetBatch Manual—522460-004
A-25
Message Descriptions
2107-E
Cause. The SUBMIT JOB command specified the name of an existing job.
Effect. The command failed.
Recovery. Retry the command, specifying a unique job name.
2108-E
Cause. The command did not specify the name of a job (a required syntax item).
Effect. The command failed.
Recovery. Retry the command, specifying a job name.
2110-E
Cause. The command specified a job number outside the allowable range 1 through
32767.
Effect. The command failed.
Recovery. Retry the command, specifying a job number in the range 1 through 32767.
2117-I
Cause. The command used wild-card characters to specify a range of attachment-set,
class, executor, or job names. No names matched the wild-card specification or names
that did match were of records to which you have no access.
Effect. None.
Recovery. Not applicable.
Job job-name already exists
You must specify a job name
Job number must be in the range 1 to 32767 inclusive
Note. This error message is applicable only for systems running G-series RVUs. For systems
running H-series RVUs, the job number range is 1 to 9999. The error message and the
recovery method change accordingly.
No { ATTACHMENT SET | CLASS | EXECUTOR | JOB } selected