NetBatch Manual
Messages
NetBatch Manual—522460-004
A-31
Message Descriptions
2143-E
Cause. The SWITCHLOG SCHEDULER command specified an EDIT file as the
scheduler’s log file. EDIT files cannot be log files.
Effect. The command failed.
Recovery. Retry the command, specifying one of these as the log file: a device; a
process; or any type of unstructured disk file except an EDIT file; or a nonexistent disk
file.
2144-E
Cause. The SELPRI job attribute specified an invalid selection priority.
Effect. The command failed.
Recovery. Retry the command, specifying a selection priority in the range 0 through 7.
2145-E
Cause. ZBAT-TKN-STARTUP-MESSAGE specified a startup message containing
more than 961 characters or omitted the message altogether.
Effect. The command failed.
Recovery. Retry the command, changing ZBAT-TKN-STARTUP-MESSAGE to specify
a startup message containing no more than 961 characters.
2146-E
Cause. The STOP JOB command specified a job whose state was EVENT, READY,
RUNNEXT, RUNNOW, SPECIAL- n, TAPE, or TIME. The command operates only on
executing, over-limit, and suspended jobs (states EXECUTING, OVER LIMIT, and
SUSPENDED).
Effect. The command failed.
Recovery. Use the DELETE JOB command to delete the job. Alternatively, retry the
STOP JOB command, specifying a job whose state is EXECUTING, OVER LIMIT, or
SUSPENDED.
Scheduler cannot write to Edit-format log file, file-name
SELPRI must be in range 0 to 7
STARTUP-MESSAGE is invalid
Job is not executing or suspended; STOP command ignored.