NetBatch-Plus Reference Manual

NetBatch-Plus Screens
NetBatch-Plus Reference Manual—522461-002
6-60
Functions
Fileseq
For ANSI-standard and IBM-standard labeled tapes only, use the Fileseq field to
specify the position of the tape file in a multifile volume.
To specify the file position, enter an integer in the range 1 through 9999. In multifile
multivolume organization, this number indicates the order of each file in the set. In
single-file organization, this number is always 1.
Fileid
For ANSI-standard and IBM-standard labeled tapes only, use the Field field to enter the
name of the tape file. The name can contain from 1 through 17 characters.
Volumeid
For ANSI-standard and IBM-standard labeled tapes only, use the Volumeid field to
specify the tape volume ID. You can enter the six-byte identification code assigned to
the volume or SCRATCH for a scratch tape. For a multivolume file, you can enter up to
seven volume IDs.
If you specified IN in the Use field, you must enter a volume ID. Otherwise, its value is
SCRATCH.
Mountmsg
Use the Mountmsg field to enter an additional message for display with the system
mount message. The message also appears with the drive-usage request printed
when the DEFINE is opened.
Functions
These functions are available on the Catalog Tape DEFINEs screen:
TMFTAPE Specifies that the tape file be used only by the HP NonStop Transaction
Management Facility (TMF) process for backups and online dumps.
Function Description
F1–Read Shows information about the DEFINE specified in the DEFINE Name field
that belongs to the defaults set named in the Set field.
* Function is available on screen, but not displayed,