NetBatch-Plus Reference Manual

NetBatch-Plus Screens
NetBatch-Plus Reference Manual—522461-002
6-71
Field Descriptions
Selpri
Use the Selpri field to specify the SELPRI job attribute for the defaults set. The
attribute specifies the selection priority of a job within its class.
To specify the attribute, enter an integer in the range 0 (lowest selection priority)
through 7 (highest selection priority).
For more information on the SELPRI job attribute, see Job Definition on page 6-102.
Pri
Use the Pri field to specify the PRI job attribute for the defaults set. The attribute
specifies the execution priority of the executor program process of a job. It also
specifies the priority of any process created by the job if the priority of that process is
not explicitly stated.
To specify the attribute, enter an integer in the range 1 (lowest execution priority)
through 199 (highest execution priority).
For more information on the PRI job attribute, see Job Definition on page 6-102.
High PIN
Use the High PIN field to set the HIGHPIN job attribute. This attribute specifies whether
a job can be started in a high PIN.
Allowed values for this field are:
•
Y = ON (job can be started in a high PIN)
•
N = OFF (job cannot be started in a high PIN; default)
When a process runs at a high PIN, it cannot communicate with a remote C-series
process.
Drives
Use the Drives field to specify the TAPEDRIVES job attribute for the defaults set. The
attribute specifies the number of tape drives required by a job.
To specify the attribute, enter an integer in the range 0 through 99 indicating the
number of tape drives.
For more information on the TAPEDRIVES job attribute, see Job Definition on
page 6-102.
Lines
Use the Lines field to specify the MAXPRINTLINES job attribute for the defaults set.
The attribute specifies the maximum number of print lines for a job output file. Because