NetBatch-Plus Reference Manual

NetBatch-Plus Screens
NetBatch-Plus Reference Manual—522461-002
6-192
Field Descriptions
When you display the screen, the NetBatch-Plus application shows the default value in
the field and a scheduler name above the field:
•
The default value is the wild-card specification of the last scheduler specified with
wild-card characters during the current session. If wild-card characters were not
used, \*.$* is the default value and specifies all schedulers on the wild-card
scheduler processes list.
•
The scheduler name above the field identifies one of these schedulers:
°
The scheduler from the defaults set associated with the signed-on user. The
NetBatch-Plus application shows the name of this scheduler if you display the
screen when no functions have been performed during the current session.
When you press F1–Read or F2–Next, the name changes to the name of the
scheduler whose details are displayed.
°
The scheduler that was the subject, directly or indirectly, of the last function
performed during the current session. When you press F1 or F2, the name
changes to the name of the scheduler whose details are displayed.
°
The scheduler whose details you displayed by pressing F1 or F2.
•
The date and time on the system where the scheduler resides appears below your
system’s date at the top of the screen.
Owner
Use the two-part Owner field to enter the Guardian user ID of a super-group user
(255, n). The ID identifies the scheduler owner and is a prerequisite to performing all
functions except F1–Read, F2–Next, and F3–Status.
In the first part of the field, enter the super-group user ID. Enter the user’s password in
the second part of the field. For more information on entering Guardian user IDs and
passwords, see Password Validation on page 6-182.
You do not have to enter a super-group user ID if it is a prerequisite to performing a
function and either of these conditions exists:
•
A super-group user ID is shown in the field, and you entered the password of that
user. The password is not required if the ID has been validated during the current
session.
•
A super-group user ID is not shown in the field, but at least one has been validated
during the current session. In these circumstances, the NetBatch-Plus application
performs the function using the most recently validated super-group user ID. The
ID used replaces the ID shown in the field.
When you display the screen, the field shows one of these user IDs:
•
The user ID from the defaults set associated with the signed-on user. The
NetBatch-Plus application shows this ID if no other IDs have been validated during
the current session.