NetBatch-Plus Reference Manual

Messages
NetBatch-Plus Reference Manual—522461-002
C-12
Error, Warning, and Informational Messages
The NEWPROCESS procedure returned an extended segment swap file error. For an
explanation of error-number, see the Guardian Procedure Errors and Messages
Manual.
You attempted to display TACL output file data by using the F2–Inquiry function. The
attempt failed because your TACL version is earlier than T9205C20 AAM. The F2–
Inquiry function displays TACL output file data only if your TACL version is equal to or
later than AAM.
An error occurred when the scheduler attempted to open a new log file. For error
details, see the scheduler log file.
You attempted to add or update a catalog or job map DEFINE without specifying its
physical file-name attribute. You must specify the attribute for all map DEFINEs.
An error occurred when the scheduler attempted to open its BATCHCTL file. For error
details, see the scheduler log file.
A warning message advising that you specified a five-character process name on a
remote system. To allow both local and remote access to the process, specify a
process name containing no more than four characters.
The function you attempted failed because you specified a tape file name (file ID) and
tape volume ID for a tape other than an ANSI-standard or IBM-standard labeled tape.
These values are required only for ANSI-standard and IBM-standard labeled tapes.
The function you attempted failed because you specified the position of a volume in a
multivolume file for a tape other than an ANSI-standard or IBM-standard labeled tape.
This value is required only for ANSI-standard and IBM-standard labeled tapes.
Extended segment swap error error-number
F2–Inquiry not available for TACL version prior to AAM
File error trying to switch to new logfile
FILE must not be spaces
File system error, on the BATCHCTL file
File/Process name can’t be networked
FILEID/VOLUME are only meaningful for ANSI or IBM
FILESECT applies to IBM,ANSI tapes