NetBatch-Plus Reference Manual

Messages
NetBatch-Plus Reference Manual—522461-002
C-26
Error, Warning, and Informational Messages
On the Executor Info screen, this message indicates the F12–Stop function suspended
operation of an executor whose state was ON or ACTIVE.
On the Job Info screen, this message indicates the F8–Delete function deleted a job
that was not executing or suspended.
Job submission failed because the job’s scheduler had the attribute
SUBMIT-ALLOWED OFF. The SUBMIT-ALLOWED attribute must be ON for a
scheduler to accept jobs submitted to it.
The F11–Suspend function suspended all processes associated with the specified job.
The F14–Switch CPU function attempted to switch the backup scheduler process with
the primary scheduler process. The attempt failed because the backup process did not
exist and could not be created in any available CPU.
The function you attempted failed because the system you specified does not exist on
your network.
The function you attempted failed because the tape volume ID specified for an ANSI-
standard or IBM-standard labeled tape is invalid. To enter a valid volume ID, enter the
six-byte identification code assigned to the volume. For scratch tapes, enter
SCRATCH. For a multivolume file, enter up to seven volume IDs.
The function you attempted failed because the integer specifying the number of tape
drives is not in the valid range 0 through 99.
Stopped Ok - Ready for use
SUBMIT-ALLOWED is OFF; the Scheduler is not accepting Job
submissions
Suspended Ok - Ready for use
SWITCHCPU SCHEDULER was requested without a backup process
System unknown
Tape volume-id (except "SCRATCH") is from 1 to 6 characters
TAPEDRIVES must be in range 0 to 99