NetBatch-Plus Reference Manual

Messages
NetBatch-Plus Reference Manual—522461-002
C-27
Error, Warning, and Informational Messages
The function you attempted failed because the execution interval specified for the
EVERY job attribute is not equal to or greater than one minute. To specify the interval
in hours and minutes, enter integers in the range 0 through 168 for hours and 0
through 59 for minutes. If hours equals 0, minutes must be greater than or equal to 1.
The F4–Add function attempted to add a new executor to the scheduler. The attempt
failed because the EXECUTOR file in the scheduler database was full. To increase the
maximum extents of the file, use the FUP ALTER command. The recommended
maximum extents for the file is 100.
The executor program specified for a job does not exist, but the scheduler scheduled
the job anyway. When the job runs, it fails with a NEWPROCESS error and is flagged
with a state of SPECIAL-3. To prevent job failure from occurring, specify a valid
executor program before execution starts.
The F10–Activate function attempted to activate a job that was not suspended. The
function can activate only suspended jobs.
The F6–Maintain function attempted to add a new class to the scheduler. The attempt
failed because the JOBCLASS file in the scheduler database was full. To increase the
maximum extents of the file, use the FUP ALTER command. The recommended
maximum extents for the file is 100.
The F12–Shutdown function attempted to shut down a scheduler already being shut
down.
The NEWPROCESS procedure was unable to allocate an internal system table.
Contact your system administrator for help.
The EVERY attribute cannot be 0:00 hours
The EXECUTOR file is full
The EXECUTOR-PROGRAM does not exist
The job to activate was not suspended
The JOBCLASS file is full
The scheduler is being SHUTDOWN
Unable to allocate map