NET/MASTER Management Services (MS) Command Reference Manual

LBANNER
PARAM
NonStop NET/MASTER MS Commands
2–188 115412 Tandem Computers Incorporated
PROCESSWEIGHT= process-weight
READY= ncl-procedure
SECEXIT= process-name [ [, process-name ] … ]
SECEXITPROCESS= logical-name
STATICPROCESS= logical-name
SWGUID={ YES | NO }
UACAUTH =file-name
UACUTIL= file-name
UADAUTH= file-name
UADUTIL= file-name
UMSFILE= file-name
Table 2-5 lists operands of the PARAM command that configure a single value and
should occur once only in the configuration file. (If the value occurs more than once,
the last value supersedes all other values.)
Table 2-5. PARAM Operands That Configure a Single Value
CEXCCF LOGFILE1 NCLDISTSRC READY
CEXDCF MDSMAPFILE NCLOBJLIB UACAUTH
DID NCLCUSTOBJ NCLQUEUESVOL UACUTIL
DSNMSECTION NCLCUSTSRC PNLCUSTSRC UADAUTH
DSNMSUBVOL NCLDISTCODE PNLDISTCODE UADUTIL
INIT NCLDISTOBJ PNLDISTSRC UMSFILE
Table 2-6 lists operands of the PARAM command that add information to a list and
can occur more than once in the configuration file. Each occurrence supplements the
information in the list.
Table 2-6. PARAM Operands That Add Information to a List
CIP CPUWEIGHT SECEXIT
CMDSVR FEATUREDISABLE
Table 2-7 lists operands of the PARAM command that occur in a group of PARAM
commands, define the logical name of a specific type of process (dynamic, global
memory manager, static, and so on), and terminate a process definition. Each must be
the last PARAM command in the group.
Table 2-7. PARAM Operands That Define Logical Names and Process Types
CIPPROCESS DSNMPROCESS GMMPROCESS STATICPROCESS
CMDPROCESS DYNAMICPROCESS SECEXITPROCESS