NET/MASTER Management Services (MS) Command Reference Manual

LBANNER
PARAM
NonStop NET/MASTER MS Commands
115412 Tandem Computers Incorporated 2–191
For each type of process, Table 2-10 summarizes the use of the PARAM operands that
define process attributes. Additionally, it indicates the default value assigned to each
operand if no configuration file is used or the operand is not explicitly specified when
defining a process type.
Table 2-10. Using PARAM Operands That Define Process Attributes
NNM Processes Processes External to NNM Default
∗
Operand Dyn GMM Stat CIP CMD DSNM SECX
PROCESSCLASS O N.A. O N.A. N.A. N.A. N.A. Depends on
file name
PROCESSCPU N.A. O O OOOONext avail.
CPU
PROCESSDEBUGTERM O O O N.A. N.A. N.A. N.A. NONE
PROCESSLIBRARY N.A. N.A. N.A. N.A. N.A. N.A. N.A. None
PROCESSNAME N.A.
$pnnn
∗
N.A.
$pGnn
∗
N.A.
$pnnn
∗
MMMMDepends on
process type
PROCESSOBJECT M M M MMMMDepends on
process type
PROCESSPARAM N.A. N.A. N.A. MMMMNone
PROCESSPRIORITY O
NCP-1
∗
O
NCP+5
∗
O
NCP-1
∗
O
NCP-1
∗
O
NCP-1
∗
O
NCP-1
∗
O
∗ ∗∗
Depends on
process type
PROCESSSWAPVOL O O O OOOOInstallation
volume
PROCESSWEIGHT O
1
∗
N.A. N.A. N.A. N.A. N.A. N.A. Depends on
process type
Dyn Dynamic process CIP Conversational interface process
GMM Global memory manager process CMD Command server process
Stat Static process DSNM DSNM process
SECX Security exit process
M Mandatory N.A. Not applicable
O Optional
NCP Priority of NonStop NET/MASTER MS control process.
nn Number allocated by NonStop NET/MASTER MS control process.
nnn Number allocated by NonStop NET/MASTER MS control process.
p Process character defined in RUN command from TACL.
∗
Default value applies when there is no configuration file or the PARAM operand is omitted when defining a process type.
∗∗
Default priority is 198 when no configuration file is used. Default priority is NCP-1 when you omit
PARAM PROCESSPRIORITY when defining a security exit process in the configuration file.