NET/MASTER Management Services (MS) Command Reference Manual

LBANNER
PARAM CIPPROCESS
NonStop NET/MASTER MS Commands
2–198 115412 Tandem Computers Incorporated
CIPPROCESS
CIPPROCESS= logical-name
specifies a logical name for a conversational interface process (CIP) that NonStop
NET/MASTER MS starts and uses to handle Distributed Systems Network
Management (DSNM) utility commands.
You can define up to 10 CIPs. For each, you must specify a unique logical name
from 1 through 12 characters long. You can use the following characters:
Alphabetic characters: A through Z and a through z
Numeric characters: 0 through 9
Other characters: ^ ~ # $ { } - . : @ [ \ ] _ ` |
Considerations
DSNM utility commands are used to start and terminate interactive sessions with
Guardian utilities. See the OPSYS command for additional information on DSNM
utility commands.
CIPs are not NonStop NET/MASTER MS processes. However, they can be
configured, started, and stopped by NonStop NET/MASTER MS in the same way
as other NonStop NET/MASTER MS processes.
If you include both the PARAM CIP and PARAM CIPPROCESS commands in the
configuration file, the PARAM CIP command has precedence. (If you include
both commands, although NonStop NET/MASTER MS creates the CIP named by
the PARAM CIPPROCESS command, NonStop NET/MASTER MS never uses it.
This applies regardless of the order in which PARAM CIP and PARAM
CIPPROCESS appear in the configuration file.) NonStop NET/MASTER MS
creates the process using the supplied information.