NET/MASTER Management Services (MS) Command Reference Manual

LBANNER
PARAM DYNAMICPROCESS
NonStop NET/MASTER MS Commands
115412 Tandem Computers Incorporated 2–213
The following table summarizes the PARAM command operands used to define
the attributes of a dynamic process:
Operand Use Comment
PROCESSCLASS O The order of this operand in the group of operands that
defines the attributes of the process is not significant.
PROCESSCPU N.A. N.A.
PROCESSDEBUGTERM O The order of this operand in the group of operands that
defines the attributes of the process is not significant.
PROCESSLIBRARY N.A. N.A.
PROCESSNAME N.A. N.A.
PROCESSOBJECT M The order of this operand in the group of operands that
defines the attributes of the process is not significant.
PROCESSPARAM N.A. N.A.
PROCESSPRIORITY O The order of this operand in the group of operands that
defines the attributes of the process is not significant.
PROCESSSWAPVOL O The order of this operand in the group of operands that
defines the attributes of the process is not significant.
PROCESSWEIGHT O The order of this operand in the group of operands that
defines the attributes of the process is not significant.
DYNAMICPROCESS M This operand must be last in the group of operands that
defines the attributes of the process.
M Mandatory N.A. Not applicable O Optional
Example
The following example defines a dynamic process. The PARAM DYNAMICPROCESS
command specifies the logical name for the process.
PARAM PROCESSOBJECT=$SYSTEM.ZNNM.NMNC0001
PARAM PROCESSCLASS=MS
PARAM PROCESSPRIORITY=144
PARAM PROCESSWEIGHT=1
PARAM DYNAMICPROCESS=MS_D02