NET/MASTER Management Services (MS) Command Reference Manual

LBANNER

PARAM PROCESSDEBUGTERM

NonStop NET/MASTER MS Commands

2–238 115412 Tandem Computers Incorporated

PROCESSDEBUGTERM

PROCESSDEBUGTERM={

device-name

| NONE }

specifies the name of a device used for debugging a process started by NonStop

NET/MASTER MS.

Note Use the PARAM PROCESSDEBUGTERM command only when directed by Tandem support personnel.

device-name

specifies the name of the terminal used to debug a process. The Inspect utility

is started at the specified terminal when NonStop NET/MASTER MS creates

and starts the process. NonStop NET/MASTER MS does not check the device

type; if you specify an incorrect device type, such as a printer rather than a

terminal, the command fails. You can specify a device name in the form:

device

subdevice

NONE

specifies that the process is not started in debug mode.

Consideration

The following table summarizes the process types for which the

PROCESSDEBUGTERM operand is applicable:

Operand Use

CIPPROCESS Not Applicable

CMDPROCESS Not Applicable

DSNMPROCESS Not Applicable

DYNAMICPROCESS Optional

GMMPROCESS Optional

SECEXITPROCESS Not Applicable