Manualshelf

NET/MASTER Management Services (MS) Command Reference Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
291292293294295296297298299300
LBANNER
PARAM PROCESSSWAPVOL
NonStop NET/MASTER MS Commands
115412 Tandem Computers Incorporated 2–245
PROCESSSWAPVOL
PROCESSSWAPVOL=$
volume
specifies the name of the swap volume used by a process. You must specify a
volume on your local system. This is the volume that contains the swap file for a
process. The swap file is used for memory swaps of the user data stack during
execution of the process.
If you omit this operand when defining a process, the default swap volume is the
volume specified by the PROCESSOBJECT operand. Otherwise, without a
configuration file, the name of the default swap volume for each process is:
$
volume
specifies the name of the volume on which NonStop NET/MASTER MS object
files are being installed.
Consideration
The PROCESSSWAPVOL operand is applicable for all process types.
Example
The following example specifies a swap volume for a process:
PARAM PROCESSSWAPVOL=$DATA