NET/MASTER Management Services (MS) Command Reference Manual

LBANNER
PSNDCTL process-spec
NonStop NET/MASTER MS Commands
115412 Tandem Computers Incorporated 2–293
PSNDCTL process-
spec
The PSNDCTL process-spec command associates a Pathway server class identifier with
a Pathway server class. You can use this command if you did not assign an identifier
to a server class when it was made available for use by NonStop NET/MASTER MS
and you now want to make the server class available to NCL. Additionally, you can
use this command after a PSNDCTL STOP command.
PSNDCTL process-spec = server-class-identifier
process-spec :
[ \ sys . ] pathmon-process-name . pathway-server-class-name
process-spec
specifies the name of the Pathway server class.
server-class-identifier
specifies a Pathway server class identifier. You can specify an identifier from one
through eight characters long, beginning with a character other than a digit. The
PSNDCTL OPEN command lists valid characters.
Considerations
The default authority level of this command is 3.
You can enter this command from any NCL procedure, including the INIT NCL
procedure, by using either the CMD core statement or the INTCMD verb.
Refer to the Introduction to PATHWAY and the PATHWAY PATHCOM Reference
Manual for introductory information about Pathway.
For related information, see the other PSNDCTL commands and the SHOW PSND
and SHOW PSNDUSER commands.
Example
The following example associates a Pathway server class identifier with a Pathway
server class:
PSNDCTL \SYS1.$PMON.SERVERCLASS1=PSC_1