NET/MASTER Management Services (MS) Command Reference Manual

LBANNER

PSNDCTL STOP

NonStop NET/MASTER MS Commands

115412 Tandem Computers Incorporated 2–297

PSNDCTL STOP The PSNDCTL STOP command disassociates a Pathway server class identifier from a

Pathway server class.

The server class must not be in use by any NCL process or the attempt to disassociate

the identifier from the server class will fail. The server class remains available for use

by NonStop NET/MASTER MS after this command and you can assign a new unique

identifier to the server class at any time; however, NCL cannot communicate with the

server class while it does not have an identifier.

The PSNDCTL process-spec command associates an identifier with a Pathway server

class.

PSNDCTL STOP=

server-class-identifier

specifies a Pathway server class identifier. You can specify an identifier from one

through eight characters long, beginning with a character other than a digit. The

PSNDCTL OPEN command lists valid characters.

Considerations

The default authority level of this command is 3.

You can enter this command from any NCL procedure, including the INIT NCL

procedure, by using either the CMD core statement or the INTCMD verb.

Refer to the Introduction to PATHWAY and the PATHWAY PATHCOM Reference

Manual for introductory information about Pathway.

For related information, see the other PSNDCTL commands and the SHOW PSND

and SHOW PSNDUSER commands.

Example

The following example disassociates an identifier from a Pathway server class:

PSNDCTL STOP=PSC_1