NET/MASTER Management Services (MS) Command Reference Manual

LBANNER
SHOW SYSPARMS
NonStop NET/MASTER MS Commands
115412 Tandem Computers Incorporated 2–389
SHOW SYSPARMS The SHOW SYSPARMS command displays a summary of the current values of
NonStop NET/MASTER MS system parameters. Since some system parameters can
be changed after NonStop NET/MASTER MS startup, some values may be different
from those used in the INIT or READY NCL procedures when NonStop
NET/MASTER MS was initialized. Entering the SHOW SYSPARMS command with
no operands displays the current values of all system parameters.
SHOW SYSPARMS[ ={ sysparms-option | * } ]
sysparms-option
specifies the system parameter(s) for which information is displayed. You can
display the value of all system parameters listed in Table 2-16.
Table 2-16. SYSPARMS Operands Displayed by SHOW SYSPARMS Command
AUTOEXEC EMSPROC NCLPRSHR SPINPUTP
CDELAY EVCMDMIN NCLTRLFF SPLABELC
CMDSTACK HELDMSG NCLTRMAX SPOUTHIC
CNMAPPLNME ID NCLUMAX SPOUTLOC
CONMSG LANG NCLXUSER SPSUBTLC
EMSBKGCOLOR LASTLOGON NETNAME SPTITLEC
EMSCOLLPNM LMSGWARN NMIQLIM SPTITLEP
EMSCOLOR LNKTRACE NRDLIM SWGUIDDSNM
EMSDISTBCP LOCKMAX OCSTIME SYSUDB
EMSDISTCOLL LOGFILEn PNLOBJPATH TCMDMAX
EMSDISTFLT LOGHIWATER PROCESSCHAR TEDITOBJ
EMSDISTPCP LOGLOWATER PWEXPIRE TOACT1
EMSDISTPFN LOGPRCNUM PWHISTORY TOACT2
EMSDISTPNM LOGPROC PWMIN TOALARM
EMSDISTPRI LOGWRAP PWRETRY TOSTART
EMSEVENTTD MAXPANEL SESSMSG TOTIME1
EMSFLTLIB MODLUSER SPERRORC TOTIME2
EMSHLITE NCLGBTRC SPERRORH TRACEFILE
EMSLINELEN NCLMAXK SPFKEYC TRACEFLAGS
EMSLINENUM NCLOBJPATH SPINPHIC
EMSMAXRATE NCLOGTRM SPINPLOC
EMSNRD NCLPEND SPINPUTH
You can also display the values of these operands using the Display/Update
SYSPARMS Settings command option in System Support Services.