NET/MASTER Management Services (MS) Command Reference Manual

Commands and Operands Organized by Function
Introduction to NonStop NET/MASTER MS Commands
1–22 115412 Tandem Computers Incorporated
Commands and
Operands Organized
by Function
The tables in this subsection summarize NonStop NET/MASTER MS commands and
operands by function. The tables show the main commands and operands in each
functional group. A command or operand may be in more than one group.
Table 1-5 lists the operands of the PROFILE command. This command is used to
configure your Operator Control Services (OCS) profile, which is partly derived from
your user ID definition record. Your user ID definition record is defined using User
ID Management Services (UMS).
Table 1-5. PROFILE Command Operands
CMDKEEP HOLD MSGPROC ROLL
CMDSEP INDENT NCLTEST TRUNC
CMDSTACK INITCMD NRDELCH UNSOL
DELCHAR MONMSG PREFEMS
EMS MSG PREFSYS
ENV MSGALARM PRFTM
GUID MSGCODE RDMIN
Table 1-6 lists Inter-NET/MASTER Connection (INMC) commands. These commands
are used to define and control links to remote NonStop NET/MASTER MS and
SOLVE management services systems.
Table 1-6. Inter-NET/MASTER Connection (INMC) Commands
LINK DEFINE LINK START SESSION DELETE SHOW LINKS
LINK DELETE LINK STOP UNIT DEFINE
LINK RESET SESSION DEFINE UNIT DELETE
Table 1-7 lists Remote Operator Control (ROC) commands. The SIGNON link-name
and SIGNOFF link-name commands are used to log on to and log off from remote
systems, respectively. The ROUTE command is used to send commands to remote
systems for execution. The results of a command are returned to the local system from
which the command is entered.
Table 1-7. Remote Operator Control (ROC) Commands
ROUTE SIGNOFF link-name SIGNON link-name