NET/MASTER Management Services (MS) Command Reference Manual

Commands and Operands Organized by Function
Introduction to NonStop NET/MASTER MS Commands
115412 Tandem Computers Incorporated 1–23
Table 1-8 lists Inter-System Routing (ISR) commands. The ISR command is used to
define how messages flow between NonStop NET/MASTER MS and SOLVE
management services systems. The SHOW ISR command is used to display ISR
definitions.
Table 1-8. Inter-System Routing (ISR) Commands
ISR SHOW ISR
Table 1-9 lists commands used to execute NCL procedures.
Table 1-9. Commands Used to Execute NCL Procedures
EXEC START
Table 1-10 lists commands used to control the execution of NCL processes.
Table 1-10. Commands Used to Control NCL Processes
FLUSH INTQ NCLQUEUE SET
GO NCLQUEUE RESET
Table 1-11 lists commands used to display information about NCL, NCL procedures,
NCL processes, and panels.
Table 1-11. Commands Used to Display NCL Information
DEBUG SHOW LOCKS SHOW NCLSTAT SHOW UDB
LIST SHOW NCL SHOW PANELS SHOW UDBUSER
NCLCHECK SHOW NCLGLBL SHOW PAUSE SHOW VARTABLES
NCLCOMP SHOW NCLOBJECT SHOW PNLOBJECT
SHOW FILEINFO SHOW NCLQUEUE SHOW PRELOAD
Table 1-12 lists commands used to define function keys and display function key
definitions.
Table 1-12. Commands Used With Function Keys
ENTER FK PF