NET/MASTER Management Services (MS) Command Reference Manual

LBANNER
TRACE RESET
NonStop NET/MASTER MS Commands
115412 Tandem Computers Incorporated 2–569
TRACE RESET The TRACE RESET command resets the trace parameter settings in the trace
parameter list (TPL) to their default values. This command can prove useful after
using the TRACE trace-spec command to make many changes to the parameter settings
if you decide some or all changes are not required. Use this command to reset
parameter settings before specifying parameter settings again.
TRACE RESET
Considerations
The default authority level of this command is 3.
You can enter this command from any NCL procedure, except the INIT NCL
procedure, by using the CMD core statement or the INTCMD verb.
For related information, see the SHOW TRACE and other TRACE commands.
Example
The following command resets the trace parameter settings in the TPL:
TRACE RESET