NET/MASTER Management Services (MS) Operator's Guide

The Recall Buffer Screen

Operator Control Services (OCS)

4–14 106379 Tandem Computers Incorporated

The Recall Buffer Screen The recall buffer screen is similar to the OCS window. The command input prompt,

however, is replaced by one of the following:

CURR: if the screen contains messages that were in the OCS message display area

when you accessed the recall buffer

PAST: when the screen contains only messages that were overwritten in the OCS

message display area

You can still issue commands from the command input line. However, if you are

expecting some messages in response, you will not be able to see those messages until

you exit from the recall buffer. The MSG QUEUED holding-mode message appears in

the information line when the response messages are available. Other commands will

act normally: for example, =X will log you off from NonStop NET/MASTER MS.

The following is an example of the recall buffer screen.

(13:52) --------------------- OPERATOR CONTROL SERVICES ----------------------

-- TOP OF BUFFER --

START INITCMD

NNM0357 PROFILE HAS CHANGED

NNM1005 START INITCMD PROCESSING COMPLETE. NCLID 000009

NNM0363 NEW TITLE SET

PROFILE

NNM0381 USERID: OPER3 TERMINAL-ID: #5561885

NNM0382 NCL PROCEDURE LIBRARY ID: $DATA.ZNCLPGN

NNM0383 USERID HAS MONITOR STATUS.

NNM0384 AUTOHOLD SETTING IS OFF AUTO.

---------- ------------------ NonStop NET/MASTER D30 ---------------- --------

PAST: