NET/MASTER Management Services (MS) Operator's Guide

The Command Stack
System Support Services
5–8 106379 Tandem Computers Incorporated
You cannot use the PROFILE GUID command to change your Guardian user ID.
Even though the profile is changed in the Command Entry facility, you will still be
identified by your Guardian user ID before the change when you access external
utilities. (Therefore, you must use the PROFILE GUID command from OCS to
change your Guardian user ID before you enter Command Entry when you access
external utilities.)
For instructions on reexecuting previously entered commands, see “The Command
Stack,” next.
The Command Stack All the commands you enter while using the Command Entry screen are saved on the
command stack. You can display the contents of the command stack, select commands
for reexecution, and delete commands from the stack. You use the F6 (PF06) function
key to access commands in the command stack:
1. The first time you press the F6 (PF06) function key after executing a command,
you retrieve that command. The command appears in the COMMAND field.
Press the ENTER key to reexecute the command.
2. To display the contents of the command stack, press the F6 (PF06) function key
again. A list of previously entered commands, from most to least recent, is
displayed, as shown here:
------------------------------- COMMAND STACK ---------------------------------
Select System Utility Command
SYS1 FUP INFO *
SYS1 SHOW PARAM
SYS1 SHOW OCS
SYS1 STATUS
SYS1 SHOW NCL
SYS1 SHOW TERMDEF=ALL
SYS1 PROFILE
In this example, FUP INFO * is the most recently executed command; PROFILE is
the least recently executed command.