NET/MASTER Management Services (MS) Operator's Guide

The OCS Details Screen
User ID Management Services (UMS)
106379 Tandem Computers Incorporated 2–11
Table 2-4. UMS OCS Details Fields (Page 2 of 2)
Field Description
Message Procedure The name of an NCL procedure that is invoked when you enter
OCS to process and respond to all messages sent to your OCS
screen. This procedure is referred to as your MSGPROC
procedure. If blank, standard message delivery applies.
Minimum Severity Class EMS and PPO messages are classified according to their level of
severity. If you are authorized to receive these messages, you can
receive messages that are at or above the following severity levels:
INFO You receive all INFO, WARN, NORM, and SER
messages. INFO messages are informational messages:
for example, notification that a NetBatch job has finished
normally.
WARN You receive all WARN, NORM, and SER messages.
WARN messages are warnings: for example, notification
that a file is empty.
NORM You receive all NORM and SER messages. NORM
messages report occurrences that are not of a critical
nature. Unless your site uses an EMSPROC procedure
that further processes event messages, all non-SER
EMS messages are considered NORM.
SER You receive only SER messages. SER messages
identify potentially critical situations: for example,
notification that a disk drive has become inoperable.
Unsolicited Message Receipt This value is the default value for your PROFILE UNSOL setting
when you enter OCS.
If Y, the unsolicited messages you are authorized to receive (as
configured by the other fields on this page of your user ID definition
record) are sent to your OCS window.
If N, no unsolicited messages are sent to your OCS window,
regardless of your user ID definition record settings.
Your OCS profile, as well as solicited and unsolicited messages,
are discussed in detail in Section 4, “Operator Control Services
(OCS).”
Initial OCS command A command, a set of commands, or an NCL procedure that is
automatically executed whenever you enter OCS. The value in this
field can be changed by using the PROFILE INITCMD command.
(See Section 4, “Operator Control Services (OCS).”)
When you have finished looking at the user ID definition record, press the F3 (PF03) or
F11 (PF11) function key to return to the User ID Management Services Primary Menu
screen.