NET/MASTER Management Services (MS) Operator's Guide

ManualsBrandsHP ManualsServerHP NonStop G-Series

Command Authority Levels

Issuing NonStop NET/MASTER MS Commands

3–2 106379 Tandem Computers Incorporated

There is, however, an exception to this general rule: if the authority level of an

operand of a command is higher than your authority level, you can still use the

operand if the operand only affects you (or an NCL procedure executing under your

user ID).

For example, by default, the ID operand of the FLUSH command requires an authority

level of 2. If you have a lower authority level, you can still issue a FLUSH ID

command if the NCL process you wish to terminate is executing under your user ID.

The command is rejected if you try to terminate an NCL process belonging to another

user.

Default authority levels for all the NonStop NET/MASTER MS commands are listed

in the NonStop NET/MASTER MS Command Reference Manual. Also, when you request

help for NonStop NET/MASTER MS commands, the default authority levels of the

command and its operands are displayed.

At your site, some NonStop NET/MASTER MS commands and command operands

may have a higher or lower command authority level than the default values. Some

commands or operands may be disabled. See your system manager if you cannot

execute a command or command operand that is necessary for your job. The authority

level for the command may have been changed, or you may need a higher command

authority level configured in your user ID definition record.

You can use the SHOW COMMANDS command to display the current authority level

of commands and operands, as the following screen shows:

(07:48) --------------------- OPERATOR CONTROL SERVICES ----------------------

SHOW COMMANDS

NNM2800 COMMANDS AVAILABLE TO USER: OPER1 WITH AUTH: 4

NNM0023 COMMAND AUTH OP-AUTH NOTE EQUATE TEXT

NNM0024 ! 0 -

NNM0024 ? 0 -

NNM0024 AT 0 2

NNM0024 AUTOHOLD 0 -

NNM0024 CANCEL 1 -

NNM0024 CLEAR 0 -

NNM0024 CLOSTERM 1 3

NNM0024 CNM 3 -

NNM0024 CS- 0 -

NNM0024 CS+ 0 -

NNM0024 DEBUG 0 -

NNM0024 DEFLINK 3 -

NNM0024 DEFMODE 4 -

NNM0024 DEFOPSET 4 -

NNM0024 DEFTRANS 4 -

NNM0024 DELLINK 3 -

NNM0024 DELMODE 4 -

NNM0024 DELOPSET 4 -

MSG QUEUED ------------------ NonStop NET/MASTER D30 ---------------- --------

M=>

Note The SHOW COMMANDS command does not display the authority level of external utility commands.