NET/MASTER Management Services (MS) Operator's Guide

The Command Input Line
Operator Control Services (OCS)
106379 Tandem Computers Incorporated 4–11
The Information Line The information line above the OCS command input line displays the following
information:
Holding-mode messages, as described earlier in this section and summarized in
Table 4-2
Table 4-2. Holding-Mode Messages
Message Description
HOLDING You have pressed the ENTER key to temporarily suspend the flow of messages to
the roll-delete message area.
AUTO HOLD AUTOHOLD ON is in effect, and the screen is frozen until you press the ENTER
key to allow the message display to wrap to the top of the roll-delete message
area.
MSG QUEUED Additional messages have arrived while the screen is frozen.
%75 LIMIT The message hold queue is 75% full.
%100 LIMIT The maximum message hold queue limit is reached.
MSGS LOST The maximum message hold queue limit is exceeded.
FS-HOLD Your OCS screen is taken over by another screen as soon as you press the
ENTER key (or another function key). This occurs only when AUTOHOLD AUTO
is set. It allows you a grace period before the OCS messages disappear from the
window.
The OCS window identifier
If you have set an OCS identifier by using the OCSID command, this identifier is
displayed at the right of the information line (see “Working With Two OCS
Windows,” later in this section, for more information).
The Command Input Line The OCS command input line is where you enter NonStop NET/MASTER MS
commands. The results of these commands are displayed in the roll-delete message
area of the OCS window from which the command was entered.
Issuing NonStop NET/MASTER MS commands from the OCS command input line is
discussed in more detail later in this section.