NET/MASTER Management Services (MS) System Management Guide

Example 1: IBM Host Controlling Two Tandem Nodes
Supporting Remote Operations
9–22 105744 Tandem Computers Incorporated
The next SCF command file excerpt configures SNAX/XF and X25AM for INMC use
on the Tandem standby node known as \NODEB shown in Figure 9-3, earlier in this
section:
COMMENT******************************************************
COMMENT Defines SNAX/XF line and subdevices connecting
COMMENT \NODEB to IBM host
COMMENT******************************************************
ASSUME line
$ ibmb1
ALTER recsize 1044
ADD pu #pu1, type (13,2), address 193,recsize 1042,maxlus 6,&
maxpts 4
ADD lu
# ibmb1, address 2,recsize 1034,TYPE (14,2),&
puname #pu1,protocol snalu0,characterset ascii
COMMENT******************************************************
COMMENT Defines X.25 lines and subdevices connecting
COMMENT \NODEB to \NODEA
COMMENT******************************************************
ASSUME line $X25A
ALTER, calls TWOWAY
ALTER, framemode dce
ALTER, svc (1,10)
ADD su #vc1,protocol ptp,devtype (9,0),recsize 1024, port 1, ACCEPTCHG ON
ADD su #vc2,protocol ptp,devtype (9,0),recsize 1024, port 2, ACCEPTCHG ON
ADD su #vc3,protocol ptp,devtype (9,0),recsize 1024, port 3, ACCEPTCHG ON
ADD su #vc4,protocol ptp,devtype (9,0),recsize 1024, port 4, ACCEPTCHG ON
ASSUME line $X25B
ALTER, calls TWOWAY
ALTER, framemode dce
ALTER, svc (1,10)
ADD su #vc1,protocol ptp,devtype (9,0),recsize 1024, port 1, ACCEPTCHG ON
ADD su #vc2,protocol ptp,devtype (9,0),recsize 1024, port 2, ACCEPTCHG ON
ADD su #vc3,protocol ptp,devtype (9,0),recsize 1024, port 3, ACCEPTCHG ON
ADD su #vc4,protocol ptp,devtype (9,0),recsize 1024, port 4, ACCEPTCHG ON