NET/MASTER Management Services (MS) System Management Guide

Operating Modes

Configuring the Processing Environment

115414 NonStop NET/MASTER MS System Management Guide 11–27

Figure 11-1. Basic Mode Programs and Processes

018

Global Memory

Manager Process

Security Exit

Process

Control Process

NC Process

xxssdd

SECEXIT

NCP

NGM

In basic mode, even if you have the resources, it is usually not necessary to define

additional GMM and security exit processes to support the workload of the single NC

process. A single GMM and security exit process is usually sufficient to handle the

workload.

Starting NonStop NET/MASTER MS in Basic Mode

There are two ways to start NonStop NET/MASTER MS in basic mode: without or

with a CONFIG file.

Basic Mode Without a CONFIG File. When starting NonStop NET/MASTER MS in basic

mode without a CONFIG file, the NCP uses a file name on disk to determine the class

of application process to start. You have two options when starting NonStop

NET/MASTER MS in basic mode without a CONFIG file:

Option 1—Start NonStop NET/MASTER MS immediately after the REPSUBSYS

phase of the Install program, without making any changes to the location or names

of NonStop NET/MASTER MS files. The application process program file name is

NMNC0001.

NonStop NET/MASTER MS starts in basic mode using its default startup

configuration. The NCP starts a dynamic NC process with the default values for

execution attributes and a logical name.