NET/MASTER Management Services (MS) System Management Guide

Operating Modes
Configuring the Processing Environment
115414 NonStop NET/MASTER MS System Management Guide 11–29
Method 3—See “Starting Application Processes by Using File Names on Disk,”
earlier in this section, for information on using process creation hints to
implicitly specify the process class.
3. Create a CONFIG file that includes or omits an application process definition for
an NC process, as appropriate.
4. Start NonStop NET/MASTER MS.
The changes take effect after the NonStop NET/MASTER MS startup phase has
finished. See Section 2, “Starting NonStop NET/MASTER MS,” for startup
instructions.
The Processing Environment Created by the Default Startup Configuration
By default, the NCP also starts the DSNM command and control processes. Figure
11-2 illustrates the processing environment created by the default startup
configuration.
By default, all DSNM program files reside in the ZDSMS subvolume on the installation
subvolume. All DSNM processes started by NonStop NET/MASTER MS have an
execution priority of one less than that of the NCP. For additional information about
the default startup configuration of the DSNM processes, refer to the Distributed
Systems Management Solutions (DSMS) System Management Guide. To start the DSNM
event monitoring processes, follow the instructions provided in “Using DSNM Event
Monitoring Processes,” later in this section.