NET/MASTER Management Services (MS) System Management Guide

Updating the Map File After the System Template File Is Updated
Maintaining the Map File
115414 NonStop NET/MASTER MS System Management Guide 12–9
9. If you did not restart NonStop NET/MASTER MS in Step 8, use these commands
to update the maps from the updated map file:
SYSPARMS MAPDEL=$SPI
SYSPARMS MAPDEL=$MSG
SYSPARMS MAPLOAD=$MSG
You do not need to reload $SPI. $SPI is automatically reloaded from the updated
map file when $MSG is reloaded.
Updating the Map File
After the System
Template File Is
Updated
If you install a new Tandem system template file or a new Tandem product that
updates the existing system template file, you must update the map file if you want
NonStop NET/MASTER MS to recognize any new tokens in the new or updated
system template file.
The steps you follow to update the map file differ according to whether you also have
user-defined tokens to map to MDOs in the updated map file. In either case, you use
the MDMAINT program to update the map file.
Updating the Map File
Without Mapping
User-Defined Tokens to
MDOs
To update the map file without mapping user-defined tokens to MDOs, you must
rebuild the $SPI map. Rebuilding the $SPI map ensures that new tokens in the system
template file are recognized by NonStop NET/MASTER MS, and that NonStop
NET/MASTER MS can process and display the new tokens as MDOs.
See “Rebuilding Standard Maps,” earlier in this section, for the syntax of the TACL
RUN command used to invoke the MDMAINT program to rebuild the standard map
$SPI.
Updating the Map File and
Mapping User-Defined
Tokens to MDOs
To update the map file and also map user-defined tokens to MDOs in the updated
map file, you must map the user-defined tokens to MDOs again and rebuild the $SPI
map. You must map the user-defined tokens to MDOs again so that they are merged
with the updated template file when the $SPI map is rebuilt.
To map user-defined tokens to MDOs again and rebuild the $SPI map, follow the steps
described in “Mapping User-Defined Tokens to MDOs,” earlier in this section, noting
the following differences:
1. Perform or confirm that you have performed Step 1.
2. Perform or confirm that you have performed Step 2.
3. Perform or confirm that you have performed Step 3.
4. Perform Step 4 using the updated template file.
5. Perform or confirm that you have performed Step 5.
6. Perform Step 6.
7. Perform Step 7.
8. Perform Step 8 as follows: if you used the ADD DEFINE command in Step 6, you
must restart NonStop NET/MASTER MS: otherwise, proceed to Step 9.
9. Perform Step 9.