NET/MASTER Management Services (MS) System Management Guide

Appendix B Default Configuration Values
Reference
115414 NonStop NET/MASTER MS System Management Guide B–1
This appendix provides reference information for the programmatically supplied and
otherwise set default configuration values. The values specified in this subsection are
the operative values if NonStop NET/MASTER Management Services (MS) is started
without a CONFIG file. Note that the p in some process or file names is the first
character of the name of the NonStop NET/MASTER MS control process (NCP), the
process character of the NonStop NET/MASTER MS system. The NCP is described in
Section 2, “Starting NonStop NET/MASTER MS.”
Table B-1 describes the default values of the PARAM command operands displayed
by the SHOW PARAM command.
Table B-1. Default Configuration Values (Page 1 of 2)
PARAM Operand Default Value
CEXCCF $isv-vol.ZNNMDATA.pCEXCCF
CEXDCF $isv-vol.ZNNMDATA.CEXDCF
CIP $pD05
CMDSVR $pDCM
DID The first four characters of the system name
DSNMSECTION Null
DSNMSUBVOL $isv-vol.ZDSMS
INIT INIT
LOGFILE1 $isv-vol.ZNNMDATA.pLGFILE1
MDSMAPFILE $isv-vol.ZNNMDATA.pMAPFILE
NCLCUSTOBJ $isv-vol.ZNNMNCO.NCLCOBJ
NCLCUSTSRC $isv-vol.ZNNMNCS
NCLDISTCODE $isv-vol.ZNNMNDO.NCODE
NCLDISTOBJ $isv-vol.ZNNMNDO.NCLDOBJ
NCLDISTSRC $isv-vol.ZNNMNDS
NCLOBJLIB ZNNMUCO
NCLQUEUESVOL $isv-vol.ZNNMDATA
PNLCUSTSRC $isv-vol.ZNNMPCS
PNLDISTCODE $isv-vol.ZNNMPDS.PCODE
PNLDISTSRC $isv-vol.ZNNMPDS
PROCESSCHAR The first character of the NCP (default is “Z”)
READY READY
SECEXIT $pNN0 (if an external security exit is present)
SWGUID YES