NET/MASTER Management Services (MS) System Management Guide

Phase 3: Add a Security Administrator User ID Definition Record
Starting NonStop NET/MASTER MS
115414 NonStop NET/MASTER MS System Management Guide 2–13
7. From the OCS command input line, if you have no further need of the activity log
file of the failed NonStop NET/MASTER MS system, close the file by issuing the
following command:
UDBCTL CLOSE= running-file-spec
Refer to the NonStop NET/MASTER MS Command Reference Manual for more
information about the UDBCTL OPEN and UDBCTL CLOSE commands. Refer to the
NonStop NET/MASTER MS Operator’s Guide for information about Activity Log Browse
commands, and how to use the Activity Log Browse facility to browse through an
activity log file that is not part of the current log set.
Information in NonStop NET/MASTER MS Manuals
Refer to the NonStop NET/MASTER Messages Manual to obtain information on
NonStop NET/MASTER MS and other messages issued during an unsuccessful
startup attempt. Other NonStop NET/MASTER MS manuals, which may contain
helpful information, are listed in “About This Manual.”
Phase 3: Add a
Security Administrator
User ID Definition
Record
In this phase, you add a user ID definition record for the security administrator. A
new NonStop NET/MASTER MS system’s database of defined users contains a
temporary user ID definition record, named INSTALL. The INSTALL user ID is
temporary: you can log on with it only once. For security reasons, NonStop
NET/MASTER MS deletes the INSTALL user ID definition record when you exit the
session with which the INSTALL user ID is used.
When logged on with the INSTALL user ID, you have access only to the features with
which user ID definition records and utility definitions are managed. Therefore, you
must add a user ID definition record that is capable of adding additional user ID
definition records.
Note If you log on using the INSTALL user ID and exit before creating another user ID definition record, you
must perform the operations described in “Reinstalling NonStop NET/MASTER MS,” later in this section.
The steps required to define a security administrator user ID definition record can be
grouped into these tasks:
Task 1: Create a user ID definition record for the security administrator.
Task 2: Grant the security administrator’s user ID access to Utility Maintenance
Services.
You need perform these tasks only once: after you start a NonStop NET/MASTER MS
system for the first time. The file that contains user ID definition records is not
overwritten by successive installations, new releases, or other updates.
Note Throughout this subsection you are asked to perform tasks that this guide discusses in more depth in
Section 4, “Managing User Access and Privileges.” The present objective is to create a user ID with
which you can explore and perform the tasks described in the remainder of this manual.