NET/MASTER Management Services (MS) System Management Guide

Phase 3: Add a Security Administrator User ID Definition Record
Starting NonStop NET/MASTER MS
2–20 115414 NonStop NET/MASTER MS System Management Guide
14. Press the F8 function key.
The UMS : User Installation Attributes panel, shown next, appears on your screen:
SCTYADMN-------------- UMS : User Installation Attributes ----------Page 4 of 5
Command ===> Function=ADD
The fields displayed below represent user attributes allocated by this
installation. The function of any attributes defined in these fields
is determined by your installation. No validation is performed against
these fields.
Installation Attribute 1 .....
Installation Attribute 2 .....
Installation Attribute 3 .....
Installation Attribute 4 .....
F1=Help F2=Split F3=File
F7=Backward F8=Forward F9=Swap F11=Menu F12=Cancel
You need not enter information on the UMS : User Installation Attributes panel
when creating the user ID definition record for the security administrator.
Section 4, “Managing User Access and Privileges,” discusses use of the panel.
15. If you granted the security administrator access to OCS, press the F8 function key,
which moves you to the UMS : OCS Details panel, and proceed to Step 16:
otherwise, skip Step 16 and proceed to Step 17.
16. To activate any of the following capabilities, move the cursor to the associated
field and type Y:
Receive EMS Messages
Monitor Status
Unsolicited Message Receipt
By activating these features, you allow the security administrator to receive
messages about logon attempts, logon failures, and potential security breaches.