NET/MASTER Messages Manual

NNM0400
Messages
106159 Tandem Computers Incorporated 2–101
NNM0400 OPEN PROCESS process_name ERROR= errno ON, LINK= linkname
DEVICE= devname
Cause. A LINK START command was issued for an INMC link that uses PTP sessions.
During link establishment, the INMC software was unable to access the named
process. This error can occur periodically in the following cases:
Each time the primary process of the PTP communications link attempts to open
the secondary process
If the primary process opened the secondary process successfully, each time the
secondary process attempts to open the primary process
process_name is the name of the process to be opened.
errno is the Guardian file-system error number.
linkname is the name of the INMC link.
devname is the name of the mailbox file.
Effect. The connection cannot be established due to the error. The INMC software will
retry the operation until either the connection is established, or a LINK STOP or LINK
RESET command is issued.
Recovery. Normally, the connection is established after a few tries and no recovery is
required. However, if the problem persists, investigate the cause of the error reported
in the error variable. Remove the cause of the problem. Once the problem is resolved,
the link will come up automatically.