NET/MASTER Messages Manual

NNM0451
Messages
106159 Tandem Computers Incorporated 2–103
NNM0450 INMC X25 INCORRECT APPLID NAME. EXPECTED= ename
ACTUAL= aname ,LINK= linkname , DEVICE= devname , UNIT= unitname
Cause. A LINK START command was issued and an X.25 virtual call was set up, but
the APPLID value used by the remote system does not match the APPLID value
configured in the session definition on this NonStop NET/MASTER MS system. This
message is generated for each unit used by the session.
ename is the APPLID value in the local session definition.
aname is the APPLID value used by the remote system.
linkname is the name of the INMC link being started.
devname is the name of the device.
unitname is the name of the unit.
Effect. The link cannot be started successfully until the APPLID values in the session
definitions on both systems are the same.
Recovery. Correct the APPLID values on one system or the other so that the session
definitions on both ends of the link use the same APPLID value (application name).
Reset the link and restart it using the LINK RESET and LINK START commands.
NNM0451 ACTIVE X.25 DEV RCVD INVALID DTE ADDR addr , LINK= linkname ,
UNIT= unitname , DEVICE= devname
Cause. A LINK START command was issued for an INMC link that has X.25 units
defined as active switched virtual circuits. The DTE address required by one of the
units has either not been configured or contains invalid characters. A valid DTE
address contains only numeric characters.
addr is the DTE address if configured.
linkname is the name of the INMC link being started.
unitname is the name of the unit that has a problem with the DTE address.
devname is the name of the device.
Effect. The unit concerned is unable to initiate an X.25 virtual call using the DTE
address supplied. Other units used by the same link are able to continue if they have
been configured correctly. If this is the only unit used by a link then the entire link
cannot be used until the problem is rectified.
Recovery. To make use of all the units used by the link, the link must be reset and
restarted using the LINK RESET and LINK START commands once the DTE address
has been supplied correctly.