NET/MASTER Messages Manual

NNM0551
Messages
106159 Tandem Computers Incorporated 2–107
NNM0511 PARAMETER IN ERROR: paramname
Cause. An ISR command was issued but an invalid operand value was specified.
paramname is the operand string that contains the invalid value.
Effect. The command is ignored.
Recovery. Specify a valid value to correct the command and retry.
NNM0512 LINK linkname UNUSABLE AS ISR CONNECTION. DOMAIN domainid
ALREADY CONNECTED
Cause. A LINK START=linkname command was issued. The INMC link became active
but was unusable as an ISR connection because the domain was already connected by
another INMC link.
linkname is the name of the INMC link.
domainid is the ID of the domain that the link attempted to connect.
Effect. The domain remains connected through the other INMC link.
Recovery. This message is informational only; no recovery action is necessary. You can
use LINK STOP to stop an INMC link.
NNM0551 THE PROGRAM OBJECT FILES ARE INCOMPLETE
Cause. During system startup, some of the NonStop NET/MASTER MS program
object files could not be found or they were not of the correct version.
Effect. The startup of the NonStop NET/MASTER MS system is abandoned.
Recovery. Make sure all NonStop NET/MASTER MS program object files are installed
properly and are of the same version. Check the PROCESSOBJECT parameter in the
configuration file (if used) to ensure that the correct object files are used. If the
problem persists, contact your Tandem support representative and provide the
following information:
Configuration file
List of the files (including the file security information) in the NCP subvolume or
specified by the PROCESSOBJECT parameter