NET/MASTER Messages Manual

NNM0579
Messages
106159 Tandem Computers Incorporated 2–119
NNM0579 USER group-number , user-number AT HOMETERM home-term STARTED
NCP objfile IN CPU cpu1 : cpu2 config-file-info trace-info
( backup-status )
Cause. Your NonStop NET/MASTER MS system was being started, and the message
was displayed to provide the following startup information:
group-number , user-number is the Guardian user ID of the user that started
NonStop NET/MASTER MS.
home-term is the name of the home terminal for NonStop
NET/MASTER MS.
objfile is the name of the NCP object file.
cpu1 is the number that identifies the processor in
which the primary process of the NCP is
executing.
cpu2 is the number that identifies the processor in
which the backup process of the NCP resides.
config-file-info is the string WITH CONFIGURATION FILE
filename if a configuration file is provided, or
the string WITHOUT CONFIGURATION FILE if
no configuration file is provided.
trace-info is the string AND TRACE trace-value if trace
flags are specified in the RUN command that
starts NonStop NET/MASTER MS. (Trace flags
are used only under the direction of Tandem
support representatives.)
backup-status provides information about the backup process
as follows:
BACKUP PROCESS NOT RUNNING
The backup of the NCP control process cannot be started because the specified
processor is not available. The backup process is automatically restarted when the
processor becomes available.
BACKUP PROCESS RUNNING
The NCP control process is executing with a backup process.
NO BACKUP PROCESS
The NCP control process is executing without a backup process. NCP was run
using the same processor for the primary and backup processes.
Effect. The startup of the NonStop NET/MASTER MS system continues.
Recovery. This message is informational only; no recovery action is necessary.