NET/MASTER Messages Manual

NNM0799
Messages
2–164 106159 Tandem Computers Incorporated
NNM0799 ENTER LOCATE PARAMETER
Cause. A LOCATE command was entered but the user ID to locate was not specified.
Effect. The operation is not performed.
Recovery. Provide the user ID and retry the command.
NNM0800 DISTRIBUTOR AVAILABLE FOR USE
Cause. An EMSDIST START command was issued, and the distributor interface was
successfully created and opened by the Event Management Service's distributor
named in the EMSDISTPFN system parameter. Events are now obtained from the
collector named in the EMSDISTCOLL system parameter.
Effect. The distributor interface is now available for use.
Recovery. This message is informational only; no recovery action is necessary.
NNM0801 DISTRIBUTOR UNAVAILABLE FOR USE
Cause. The EMSDIST STOP command was issued or an error occurred on the NonStop
NET/MASTER MS distributor interface. If the message appears as a result of an error,
there will be other messages that provide information about the error.
Effect. The NonStop NET/MASTER MS distributor interface is stopped, and
distributor events are no longer processed.
Recovery. If the message appears as a result of an error, refer to the accompanying
messages to determine the appropriate action to take; otherwise, you do not need to
take any action.
NNM0803 EMSDIST START COMMAND ACCEPTED
Cause. An EMSDIST START Command was accepted and will be processed. The
command starts the NonStop NET/MASTER MS distributor interface to read and
process events.
Effect. Starting of the distributor interface begins.
Recovery. This message is informational only; no recovery action is necessary.