NET/MASTER Messages Manual

NNM0009
Messages
2–4 106159 Tandem Computers Incorporated
NNM0009 process_name ( objfile ) ABENDING, TRAP= trapid ,
THRDID= thrdss / thrdno , trapname
Cause. A system trap occurred in the process.
process_name is the name of the failed process.
objfile is the file name of the object code that caused the problem.
trapid is an ID to help your Tandem support representative identify the
problem.
thrdss thrdno is the identification for the thread.
trapname is the name of the trap that occurred.
Effect. The process abends. If the process is a static process, it is restarted.
Recovery. The message includes useful information to help your Tandem support
representative to identify the problem. Contact the representative, providing the
following information:
Displayed message
Abend dump file
Activity and EMS logs
NNM0010 TRACE DISABLED TO FILE filename
Cause. A SYSPARMS TRACEFLAGS=0 command was issued and tracing to the file
was disabled.
filename is the file name specified by the TRACEFILE system parameter.
Effect. Tracing is disabled.
Recovery. This message is informational only; no recovery action is necessary.
NNM0011 process_name ENGINE MEMORY CRITICAL
Cause. The process was running low on memory. This situation will rectify itself
when memory becomes available. If no memory becomes available, the process may
abend.
process_name is the name of the process that has the memory problem.
Effect. Only critical memory requests are satisfied until more memory is made
available.
Recovery. Refer the message to your system manager. The manager should try to
recover space on the swap disk volume.