NET/MASTER Messages Manual

NNM0978
Messages
2–184 106159 Tandem Computers Incorporated
NNM0978 BEGINNING OF DATA
Cause. NonStop NET/MASTER is using two sources for the event help message. You
pressed the F10 function key to access the ZHLPCVP event help UDB for help on a
previous EMS event message, but the ZHLPPCVP UDB contains no earlier data.
Effect. The current help information remains displayed.
Recovery. Type the ID of the event message on which you want help in the message ID
field, and press the ENTER key. This enables retrieval of the help information from
the primary EMS event help file specified in the EMSEVENTTD system parameter.
NNM0979 END OF DATA
Cause. NonStop NET/MASTER is using two sources for the event help message. You
pressed the F11 function key to access the ZHLPCVP event help UDB for help on the
next EMS event message, but the ZHLPCVP UDB contains no further data.
Effect. The current help information remains displayed.
Recovery. Type the ID of the event message on which you want help in the message ID
field, and press the ENTER key. This enables retrieval of the help information from
the primary EMS event help file specified in the EMSEVENTTD system parameter.
NNM0980 shutdown-command EXECUTED ON TERMINAL device-name
Cause. An FSTOP, SHUTDOWN, or SHUTDOWN $ABEND$ command
( shutdown-command ) was issued to shut down a NonStop NET/MASTER MS
system externally by using the NNM shutdown utility.
device-name identifies the terminal from which the utility was executed.
Effect. If the command is SHUTDOWN $ABEND$, shutdown starts immediately,
irrespective of whether the target NonStop NET/MASTER MS system is initializing or
is running already.
If the command is FSTOP, shutdown starts immediately only if the target NonStop
NET/MASTER MS system is running already. If the system is initializing, FSTOP
waits until the system is running, and then executes the shutdown.
If the command is SHUTDOWN, the target NonStop NET/MASTER MS system
prevents further logons and waits for all users to log off before starting the shutdown.
Recovery. This message is informational only; no recovery action is necessary.