NET/MASTER Messages Manual

NNM1025
Messages
106159 Tandem Computers Incorporated 2–197
NNM1022 FLUSH COMMAND ACCEPTED
Cause. A FLUSH command was issued and accepted.
Effect. The current NCL process is terminated.
Recovery. This message is informational only; no recovery action is necessary.
NNM1023 command COMMAND INVALID FOR MSGPROC
Cause. A command was issued for a MSGPROC procedure but the operation was
invalid.
command identifies the command that caused the error.
Effect. The MSGPROC procedure is not affected.
Recovery. This message is informational only; no recovery action is necessary.
NNM1024 NCL PROCESS NOT UNIQUELY IDENTIFIED
Cause. An END, FLUSH, GO, or INTQ command was issued without specifying the
ID of an NCL process, and there was more than one NCL process under the control of
the user. An NCL process must be identified.
Effect. No NCL processes are affected.
Recovery. Specify the ID of the target NCL process and retry the command. If you do
not know the ID, use the SHOW NCL command to list the IDs.
NNM1025 NO USER NCL PROCEDURE EXECUTING
Cause. A FLUSH command was issued but the NCL process to be terminated could
not be found.
Effect. The command is ignored.
Recovery. This message is informational only; no recovery action is necessary. You can
use the SHOW NCL command to list the NCL processes.