NET/MASTER Messages Manual

NNM1045
Messages
106159 Tandem Computers Incorporated 2–205
NNM1042 MESSAGE(S) LOST, INTREAD QUEUE LIMIT EXCEEDED
Cause. An NCL procedure issued a command using the INTCMD verb or an INTQ
command was issued to pass data to the procedure from OCS, but the number of
messages that can be queued to the dependent request or response queue of the
procedure exceeded the limit as set by the NMIQLIM system parameter. The default
limit is 1000.
Effect. One or more messages are discarded and processing continues.
Recovery. Refer the message to your system manager. The manager can use the
SYSPARMS NMIQLIM command to increase the limit on the number of messages that
a queue can handle.
NNM1043 SPECIFIED NCL PROCEDURE NOT FOUND
Cause. A SHOW NCL ID= command was issued but the specified process could not be
found. The procedure may have terminated.
Effect. The process is not found.
Recovery. You can use the SHOW NCL=ALL command to list the IDs of the NCL
processes.
NNM1044 list_type LIST OF NCL GLOBAL VARIABLES FOLLOWS
Cause. A SHOW NCLGLBL command was issued, and the message is part of the
response. The line begins the listing of the NCL global variables.
list_type is either FULL or SELECTIVE. A full list gives only the names of the
variables while a selective list displays the contents of the variables and
the lengths as well.
Effect. The listing of NCL global variables follows.
Recovery. This message is informational only; no recovery action is necessary.
NNM1045 global_variable_name
Cause. A SHOW NCLGLBL command was issued, and the message is part of the
response. The line lists one of the NCL global variable names.
Effect. An NCL global variable is listed.
Recovery. This message is informational only; no recovery action is necessary.