NET/MASTER Messages Manual

NNM1086
Messages
106159 Tandem Computers Incorporated 2–221
NNM1083 NO DEBUG SESSION CURRENTLY RUNNING
Cause. A DEBUG command was issued but no debug sessions were found.
Effect. The debug operation is not performed.
Recovery. Use the DEBUG START command to start a debug session.
NNM1084 NO NCLID HAS BEEN SPECIFIED AND NO DEFAULT HAS BEEN SET
Cause. A DEBUG command was issued but an NCL process was not specified, and
there was no default NCL process.
Effect. The debug operation is not performed.
Recovery. Specify the ID of the NCL process and retry the command or use the DEBUG
SET ID=nclid command to set the default NCL process.
NNM1085 MULTIPLE LOGON ENVIRONMENTS EXIST FOR THIS USER. PLEASE
SPECIFY TERMINAL
Cause. A DEBUG START command was issued but a user that had more than one
logon session with the NonStop NET/MASTER MS system was specified.
Effect. The debug session is not started.
Recovery. Specify the terminal together with the user to differentiate between the
sessions and retry the command.
NNM1086 THE SPECIFIED TERMINAL NAME AND/OR USER NAME DOES NOT EXIST
Cause. A DEBUG START command was issued but the specified user or terminal was
not found.
Effect. The debug session is not started.
Recovery. Use the SHOW USERS command to obtain information about the users and
terminals in the NonStop NET/MASTER MS system. Specify the correct user and
terminal, and retry the DEBUG START command.