NET/MASTER Messages Manual

NNM1087
Messages
2–222 106159 Tandem Computers Incorporated
NNM1087 WINDOW window_number IS NOT OPEN
Cause. A DEBUG START command was issued but the specified window was not
open.
window_number is either 1 or 2.
Effect. The debug session is not started.
Recovery. Specify a correct window or open the window and retry the command.
NNM1088 number_of_procs NCL PROCESSES TARGETED IN WINDOW window_number
Cause. A DEBUG START command was issued, and a debug session was started on
the NCL processes in your environments that use the stated window.
number_of_procs is the number of current NCL processes or NO if none.
window_number identifies the window that the NCL processes use: 1 or 2.
Effect. The NCL processes are now under the debug session.
Recovery. This message is informational only; no recovery action is necessary.
NNM1089 number_of_procs NCL PROCESSES EXECUTING IN THE TARGET
ENVIRONMENT
Cause. A DEBUG START command was issued, and a debug session was started on
the NCL processes in the target environment.
number_of_procs is the number of NCL processes under the session. NO is
returned if there are no NCL processes running under
the session.
Effect. The NCL processes are now under the debug session.
Recovery. This message is informational only; no recovery action is necessary.