NET/MASTER Messages Manual

NNM1098
Messages
106159 Tandem Computers Incorporated 2–227
Use the error number and the sense code to determine the actions to take.
INVALID TERMINAL DATA
The NonStop NET/MASTER MS system received invalid data from the terminal.
The condition may occur when a TACL program (or some other program)
competes with the NonStop NET/MASTER MS system for access to the terminal.
Ensure that:
Any TACL or COMINT program running on the terminal is paused, for
example, through the PAUSE command
No other programs are accessing the terminal
There are no faults with the physical connection of the terminal
INVALID TERMINAL TYPE
The terminal is of an unsupported type. Supported types are the IBM 3270 and
Tandem 6530 class of devices. Ensure that the terminal is of the correct type or is
emulating a terminal of the correct type.
NO FUNCTION KEY RETURNED
The NonStop NET/MASTER MS system received an invalid function key value
from the terminal. The condition may occur when a TACL program (or some
other program) competes with the NonStop NET/MASTER MS system for access
to the terminal. Ensure that:
Any TACL or COMINT program running on the terminal is paused
No other programs are accessing the terminal
There are no faults with the physical connection of the terminal
OUT OF MEMORY
A NonStop NET/MASTER MS process has detected an out-of-memory condition.
Try to recover disk space from the swap volume. If the condition persists, contact
the Tandem support representative, and provide the following information:
SWAP parameter (see the TACL RUN command) used when initializing the
NonStop NET/MASTER MS system and the amount of available disk space
NCL applications that were running in the NonStop NET/MASTER process
Frequency of the out-of-memory condition
Possible relationships between any application that has been run in the past
and the out-of-memory condition
Time when the system was last initialized
TERM BUF SIZE EXCEEDED
The terminal buffer became full while a panel was being displayed. A NonStop
NET/MASTER MS system uses an output buffer of about 4.1 KB (Tandem 6530
terminals) or 8 KB (IBM 3270 terminals) for panels. Reduce the number of fields in
the panel or disable color display to economize on the transferred data. If the
problem persists, the message indicates an internal error. Refer the message to